October 20, 2009

Weaving Lotus Flower (Part 3)

STEP BY STEP HOW TO WEAVE LOTUS FLOWER
PART 3

From part 2

fold ribbon backward and front
to form triangle.


Turn it over.

Slot the ribbon into the side
of the square.

Turn over, it will pass through
on top of the ribbon.

Pull it out to tighten.

Do the same thing
again, over and over.


Turn it over.

Slot into the square.


Pull it out to tighten it.

Repeat all the step again and
when done it look like this.

Cut ribbon about the tip of
the triangle.

Cut all the corner
of the ribbon as shown.

Slot the cut corner ribbon
into the square.
Repeat all cut ribbon.

Finally it done.
Top view.

Side view.

October 19, 2009

Weaving Lotus Flower (Part 2)

STEP BY STEP HOW TO WEAVE LOTUS FLOWER
PART 2

From Part 1

Fold darker pink
ribbon downward.

Take light pink ribbon from left,
slot into the square
under darker pink ribbon.

Pull out light pink ribbon
from bottom of the square

Repeat the step again.
When you done
it will look like this.


Fold ribbon backward
and front to form
a triangle as shown.


Turn it over.

Cut the ribbon length of square.

Slot the cut ribbon
inside the square.

 
Turn it over.

Do the same thing again.
Fold ribbon backward
and front to form a triangle.


Turn it over. Cut the ribbon
length of square.

Slot the cut
ribbon into the square.

Turn it over.

Do the same thing again.
Repeat all the four corner.
It will look like this.

Weaving Lotus Flower (Part 1)

STEP BY STEP HOW TO WEAVE LOTUS FLOWER
PART 1

You need 4 strips of Ribbon.
Use one or two different colour of your choice.
Each length of ribbon about 50cm long.

Fold ribbon into half.

 
Overlap each ribbon.


 
Until it form a square.

Tighten it.

From top, fold ribbon one by one.


Slot the last ribbon
under the first ribbon to tighten it.
Until it form a square again.

 

Turn over, do the same thing again.
From top, fold ribbon one by one.

 
Slot the last ribbon under
the first ribbon to tighten it.

 Turn it over.

 
Fold ribbon backward
and front to form
triangle.


 
Slot ribbon into the
side of the square to tighten it.


Do the same thing again.
Repeat the step over and over.


Slot ribbon into side of the square
to tighten it.


Repeat all the step again.
After you done, its look like this.